Alimak Scando 450

Small Construction Elevator

Features
Payload capacity	2,000 kg
Speed	0–54 m/min.
Max. lifting height	150 m
Car width (internal)	1.4 m
Car length (internal)	2.0–3.2m
Car height (internal)	2.13 m
Motor control	DOL/FC
No. of motors	1-2
Safety device type	GF
Power supply range	380–500 V, 50 or 60 Hz, 3 phase
Type of mast	450, Tubular steel with integrated rack
Length mast section	1.508 m
Weight mast section	68 kg
Rack module	5

Alimak Scando 450 hoist for personnel and materials

View complete specifications of the Alimak Scando 450 in PDF

Description

SCANDO 450 is a total upgrade of the ALIMAK CH construction hoist range first launched in 1998. Over 600 units of the CH range have been delivered and the modernization program encompassing new technology further strengthens the light and medium range construction hoists.

ALIMAK SCANDO 450 offers greater efficiency and improved durability, with lower energy consumption and reduced cost of ownership. Accessibility is improved by the use of the new microprocessor based control system, ALC II, which can solve many site logistic problems. For example, the system reduces waiting times by storing all calls from the landings and sending the hoist that is logistically nearest to a landing to pick up passengers.

ALIMAK SCANDO 450 also gets a new frequency control unit (FC), with closed-loop, which gives very smooth starting and stopping with low starting current and less wear and tear.

Metro's Additional Options and Accessories
Base Platform with Ramp or Stairs	The standard size base platform is typically 8' x 8' with a 30' ramp connecting to it. Metro can sell or lease any size base platform with a customized ramp or stairs. A shorter ramp or stairs is sometimes necessary when spacing is tight.
Maintenance and Service Agreements	Metro can service and maintain your elevator to reduce and minimize downtimes anywhere in just about any state across the country.
Factory Trained Union Personnel	Whether your project requires union labor or not, Metro uses installers and service techs that are certified the International Union of Elevator Constructors (IUEC)
Tie-ins	Securing the elevator tower to your building sometimes requires specially engineered tie-ins. Metro Elevator's fabricating shop has the personnel and expertise to build about any tie-in necessary for the project.
Landing Gates	If your project requires needs something other than standard, Metro's fabricators can design and build the customized landing gates when required.
Customized Upper Platforms	Sometimes it's impossible to position the base unit so that all upper landings are flush with the elevator car. If that is your situation, Metro can fabricate and install customized upper platforms necessary to close the gap between the elevator car and the gate.
Steel Base Pad	If you lease one of our temporary elevators, it makes sense in most situations to use our engineered steel base pad instead of pouring and removing a concrete pad. The steel base pads we lease are for the 30 passenger Champion Elevators. We can also design and fabricate a steel base pad for any type and size elevator you may be interested in purchasing.

Contact us | View site map